Recent content by BigBoss

Pretty much finished it :)

So it is not finished, but I thought an update would be nice :) 3D printing is so cool.

Progress :)

So I have no idea if anyone is still following this thread but if they are good things are on the way. A Mate got a 3D printer the other day (this is going to be fun :) ) My hope is to create a complete faceplate to replace the stock Omega plate, if it works I will upload the design and share it...

I got a SS grille and cut out all the mesh, then replaced it with the SSV mesh as above, I attached this new mesh with epoxy then sanded it back.

Oh haha nice, welcome to Perth, can't Mace do a remote tune? You north or south of the river?

Thanks Mate, I just went at it with my Dremel but you really don't need to cut much out of it, just enough to pull your wiring loom through. From memory it was pretty easy to mount in there just a couple of screws through the glove box plastic I think, pretty self explanatory when you pull it...

Hey Lads, I haven't been around lately, been busy on a new project anyway the other day I was driving around in traffic and the "Battery saving mode" became active. This did not seam to effect anything however when I got home (after checking the terminals) I restarted the car (it cranked...

So a couple of mates put this add together for Just Car insurance using my Commodore, give them a thumbs up if you have the time :) {{ http://www.justcarinsurancereeldeal.com.au/view/52d949f7d81acf941b0000fc }}

Just a couple of snaps I took after a clean, it still polishes up quite well.

Thanks Mate, I was just a couple of km/h over, I blame the Porsche that had just overtaken me. Raspberry Pie is really cool tech, best of luck with it.

There we go Lads, a delightful snap from Mr Plod

Thanks guys :) I will upload some pics after harvest, The exhaust is from a SS it cost $100 or so.

VTProductions: I should be doing a new photo shoot soon. Shifty: I could install it no problems, will PM you.

MAAAAAAD gotta love a custom job!