Recent content by defa

i should have had a look at the Tb but i didn't. it doesn't just run bad. it runs really crap. while sitting on a 90-110 it misses and backfires when ya sit it at about 1500 it misses, in park that is

nah. starts good. i had a thought maybe the fuel pressure reg was playing up. but i don't have any pressure testing gear here and i didn't have a spare one to try.

my mother inlaws s2 vn v6 is running like crap. it idles carp, runs crap. back fires but as soon as it is above around 2000 it seems to kick in and run ok. i hooked my laptop up today it and it only came up with one fault and that was 34 which is low voltage from the map sensor. but it does...

I am after one Buick V6 turbo piston. i can get one form the states, but postage is the costly bit. if anyone has one sitting around or a full set they want to get rid of let me know. although i am doubting it. must be STD size. also need a set of rings

how much for an AC compressor

i got out bid on that adapter. so still if anyone knows of a second hand flywheel that would be great..

thanks for that. i might look into it if i don't get this adapter. i would have thought someone would have an old flywheel there weren't using. but i must have been wrong..

where is this place your are talking about. and CRS (castlemaine rod shop) is in castlemaine, victoria. anyway.. 200 cheaper is better.. your car being a series 2 is different to a series 1 pattern. do you know if they do series 1 auto to manual flywheels..

i have two s1 manual flywheels here now. i have seen the adapter on ebay. i saw that before i posted this.. i was just hoping someone might have one sitting around doing nothing the wanted to get rid of. i do know the difference between them both. never really seen many auto pattern flywheels...

is it a series 1 manual flywheel. or a series 1 flywheel with an auto pattern??? ya can send me a measurement of the holes from centre to centre if ya want

6 bolts.. the auto pattern not the manual pattern. i have bought an engine but it is an auto pattern and i want to convert it to manual.. which has been done plenty of times

I am after a vn v6 seriea 1 flywheel to suit an auto motor. i take it Castlemaine rod shop are they only ones who make them, but i was after a secondhand one to save a few $$$ as i am short of cash.. if anyone has one for sale please let me know.

i spoke to a bloke today. he is in mount gambier. i have heard good things about him.. he has a place outside of town. he said 318.50 sounds a bit much to for a basic balance on a v6 and said he may be able to do the hole lot including adding mallory for a bit over 300. he said he would like...

yeah they are not too far from the min.. thanks for that...

can anyone tell me the standard side of the crank for the main journals and the bigend journals. i want to check mine..