Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.

New Posts Contact us

Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

Recent content by junkyarddog87

  1. J

    VY CONVERSION NEED HELP!!

    I just replaced the engine in my vy II, as my first efi swap (I have done many carby engines over the years) I took it slowly and took mental notes of where everything went, took me a day and a half. I had been quoted from several places locally $750-$950 to remove and install, and managed to do...
  2. J

    VS not starting on keyturn until door unlock botton pressed

    My vs sIII ute was the same, in the end it turned out my key housing was cracked enough it wouldnt contact the metal rings around the barrel. I bodgied it up with some glue and never had an issue again.
  3. J

    Are VS v6 and v8 axles the same?

    Cheers Guys, the numbers matched up so I whipped them out and swapped them this afternoon, noise is GONE!! The vn one was marginally different, being slightly after the spline is thicker, but that may have been manufacturing changes, either way it is now driving quietly, quite a large groove was...
  4. J

    Are VS v6 and v8 axles the same?

    Reading further on I see that vs utes rear track are 1478mm the same as a vn sedan's, is there a good chance I can pinch the axle from my donor car (for another project) and run that axle without stressing anything?
  5. J

    Are VS v6 and v8 axles the same?

    Long story short, I have had a squeak in my drivers side rear wheel since I bought my ute (2000 model series III vs ute) , thinking it was just worn brake pads I drove it around for approximately 1300km unti I went past an auto shop the other day and picked up some pads.... PUlling hte...
  6. J

    My june 00 vt S2 executive

    Cheers bud, its handy to have every tool imagineable between myself and the old man to get things done, the only tools we need but dont have are a hoist and a tech2 lol, that being said everything has to be done to a tight budget or the wife sh*ts a brick at me. Anyway went to pickles...
  7. J

    My june 00 vt S2 executive

    So here is my vt series 2 I bought a few years back for $700, it was pretty rough when I got it and still is in spots, anyhow when I got it I just made it roadworthy and drove it around, then a year and a half back I cancelled the rego and it sat in my yard. I can do pretty much anything myself...
  8. J

    VG HSV LS #008 - v6 manual stocker.

    Cheers guys, a lot of the LS series were v8's 54 in total LS utes were made, im not sure how many were 5L's or v6's though. The engine appears stock apart from a fairly large quiet exhaust, it does have enough power for now, but I have just picked up a second motor I might have a play with...
  9. J

    Getting a Car

    I have an old rolla as my daily, 45 bucks usually fills it and lasts me 450km of fairly modest driving. They do fall victims of rust, rear guards, sills, front guards, spare tyre well. Reliable as hell, it sat in my driveway for 6 months once, 45 minutes on the charger it fired up relatively...
  10. J

    Mattys Silver VH SL/E

    Nice vh mate, it looks pretty straight which is a great start.
  11. J

    VG HSV LS #008 - v6 manual stocker.

    Hi there I am new here, and here is my ute im currently working on to replace my very tired datsun ute. Its more or less a stock v6 5 speed, has 16" wheels, and has just been fully kitted out with nolathane bushes... The engine goes quite well, the injectors seem to leak down after a...
Top