Recent content by lildavo

after polshing

inside before cleaning out and cleaning up seats

day i got the statesman home before washing and polishing

hey all this is my new wh international statesman i picked up for 2500 with rego only 213000km on it sat around in the sun for awhile so did suffer from some paint fade most was fixed after a quick polish. make: holden model: wh statesman international engine: gen III ls1 transmission: stock...

well i got a set of vt ss 17s on my vq and got the rears scrubbing on the inner gaurd and just clears the supension arm. has anyone done the vr/vs irs conversion i can get basicaly the whole rear end bar the diff and sub fram from the wreakers for 150 is it as simple as just unbolding the...

Only update so far as is I got some rear leather wh seats for free so I had a go at fitting into my car swapped bottom drams and changed mounting for back rest I do have a gap since wh have arm rest which is why iv got a gap

Just did a test so the heater tap isn't letting coolant through unles I physical push the arm in my self then get nice warm heat so take it it's a vac problem I got no idea where these sola lids are that control the vacuum iv had the radio fascia out before hut couldn't see them.

Heater hoses seem to not blocked up pulled my heat tap off pushed the arm on to open it up it opens makes a pop noise when it shuts water will flow through it open so don't know if my vac lines are stuffed how do I cheak that coolant is getting past the heater tap only way I throught was hook it...

It's a climate control one too but I don't think any coolant goes through the cabin atm iv had the car up to temp all hoes feel cold so I'll take the tap off today and see if blocked or rusted or somthing

Also the heater tap pipes going into firewall wernt hot at all same two inside the car top radiator hose pipe was pretty warm.

Heater tap looks pretty new I did have to adjust a setting on the control unit today but no sensors are saying there fault seems to switch between vents fine. Just yeah no heater as of yet. Vac line doesn't seem to to lose or anything on the Tao it self. Where about is the connecting rod like...

My vq heater will not work, everything ells works fine just won't get any heat, I did a self dai on the unit and it came back fine. What ells is there I should be looking for? It runs the two pipe heater tap as well it's giving heat once but didn't last long before went cold again

Yeah just been having trouble finding a vq one some exhuast shops say they can't get them anymore. This one is 50 bucks but yeah I'm no welder I'd take it the middle part has to be extended to make it past the axel where it bends to clear it

I got offered a cat back off a vr v6 with irs now I know a stato is longer but would the vr cat back bolt up and just need extending or dw about it and just get one suited to vq

So iv made sure my dash is set to 80 fuel tank but when Iv filled it the needle never goes to full sits at a quiet mark the fuel in tank reading will show 80 to 81 in the tank but also the gauge will drop rapidly so once it's at half way I checked fuel in the tank reading was showing 60l was in...