Been a pretty depressing couple months for the car.
Sent it away for:
- valley gaskets
- fuel pressure reg
- injectors and a full freshen up of that entire area…
As it was getting delivered, the motors new found pressured cooling system decided that the head gasket was no long fit to hold...
Also, in the interest of keeping parts available for people wanting to replace broken / missing bits - Again, build ninja came in clutch to build us a centre belt rear cover/eschelon.
I could’ve smoothed it out - but the finish is pretty nice straight off the printer...
Being me, I couldn’t let ‘good enough’ be - so I’ve replaced all the interior roof, door & boot lights… now just need a matching warmth footwell globes… it never ends.
Solid thread dig I know - but I would add to this, to unscrew the bottom & side screws of the door trims and poke the tabs at the same time…
Popped a lens trying the original method, the rest I did partially from behind and it was mint
Long time between posts - still plotting slot, paint is progresssively failing but it is what it is…
Auctuator/door luck has been abit Dicky since replacing it 2-3 years back… it ended up breaking the exterior door handle which is annoying - thankfully holmart had a proper chrome handle in my...
epic thread dig I know - but I have arranged to have these remade in CAD & 3D printed - They turned out so great, hopefully this post helps others.
This post talks about the process and getting the donor parts together to arrange the remake...