Hi all,
I'm after a paint code for my 2018 Zb Calais V. It's called Cosmic Grey. I'm looking for some touch up paint. Any help would be greatly appreciated as I can't find it anywhere around the car id plates.
Cheers.
Hi guys,
Just purchased a 2013 VF MY 14 Evoke Sportwagon, July 2013 build.
There are no guidelines on the reverse screen.
I contacted a Holden (GM) dealership to get a software update and the service manager told me it is not guaranteed the lines will be there after the update and it would cost...
Hi all. I drive a VZ 6cyl auto. This morning I hoped into the car and it just wouldn't start. It was ticking over, coughing & splattering and then after around 5 goes it started with a bit of acceleration. It blew heaps of light blue smoke for around 3 seconds then all was fine. Started no...
Problem fixed. I replaced the switch assembly and the problem was still there. Took the car to Holden and had the resistor replaced. All's good after a few hungie bucks :)
Hi guys,
Just need help as to how to put the door seal back on. I've taken the passenger side door seal ½ off around the front and top and it just doesn't go back on flush. Is there a secret to putting it back on properly? I'm lost :hmmm:
Will do. I thought it would be a bit weak. I will give it a shot next week and I'll let you know how it goes. I will always try something once and seems easy enough. Do the dials just pull off and would I take them off before the centre trim assembly or after?
You know what, I will give it a go. I noticed on the manual it shows the model with climate control. Mine is an exec with the 3 dials. Is it exactly the same to remove? Would coat hanger wire be good enough or should I get thicker?
Thanks again PaulSV6 but mate you must be joking it's piss easy. You practically got to tear out the whole centre console and the radio assembly which you need the special tool that I don't have and then rip out the centre trim assembly which even with the great info you've provided I'd end up...
Thanks PaulSV6, I checked out the relay and it's fine. HoldenVTman seem to be right....it's buggard and loose wire means pulling the whole blimpkin dash apart just to get behind the dial to check. Job for my Holden dealer by the looks of things and big $$$$ to be spent.
Just wanted to know if...