Recent content by vortex99ozman

All I meant was why would they wast money on a wiring loom that can't be utilised. Could pit a USB port there if the voltage is correct!

That dosnt make sense for Crewman models tho.

Found this plug behind a blanking plug on my 2005 crewman anyone know what it's for?

I believe from the clips I've seen on YouTube its Loctited in.

Just for my own curiosity I contacted a Holden dealer to source a PCV valve and they sent a pic as per attachment. Gathering thats the elbow that clips into the valve in the rocker cover. They do sell the covers with a valve and gasket for $283. Thier checking if they can get the valve on its...

2005 VZ Crewman new oil and filter every 6 months, timing chain replaced well looked after. Over last 2 services just starting to find carbon granules in filter and some oil discolouration at the oil fill point. I know all about the left hand rocker issue with the PCV valve and the lack of...

Have a 2005 Crewman with Alloytec V6. Change oil and filter every 6months. Timing chain replaces about 3 years ago. Recently I have noticed a condensation build up at the oil fill point causing a yellowy type sludge. Also in the oil filter a build up of what looks like carbon granules. Ran a...

As per title, will VX steering column shroud fit a VZ? Crewman 2005

Ad per title, will VX steering column shroud fit a VZ?

All in excellent condition, will replace terminals and slip ring and eliminate earth leakage with earth wire from battery negative to engine block.

VZ crewman 2005 3.6. For a number of years out of the blue it will not start. All rates happens is a clicking sound. Has new battery, well maintained, no error codes. Will start normally after a minute or 2. Wriggling battery terminals which could be just a coincidence will start. Even after a...

When driving my drivers side window slightly drops just enough to rattle. If i raise it it stops or lower just a toucn it stops. I have removed door skin and investigated, have found nothing loose or broken. Could the motor be backing off slightly? As any one knows removing window motors are a...

The mechanic at the holden branch said to take radiato cap off and pour some coolant slowly in then run the car for 10 minutes with radiator cap off and heater on. Let settle for half hour then recheck the coolant level. Take car for drive then recheck overfill tank again. When I was running it...

A problem i just encounted with my 2005 crewman is the heater tap on the top right hand side of the motor. It can leak from the opening/closing linkage and usuall runs down to the bottom of the transmission. Initial thought are that you have a trany leak but if you take the engine cover off and...

I have a leaking heater tap and the replacement cost is $55 from local Holden dealer. When replacing this do i need to bleed the air from the cooling system at all so I dont get cavitation and other issues with the cooling system?