Search results

Family has a TS Astra. Pump became noisy, then 2 weeks later had loss of power steering. No fluid loss at all, no damage to rack. Do I assume p/s pump to be the only part to be at fault? Do I require to check codes? Is the ECU connected to these pumps [As in, does ecu shut off pump with low...

VU Commodore Ute V8 Originally it had a SDM fault code with an airbag light. I replaced the SDM Module and cleared codes. It fixed the problem with airbag light not returning. Note: All numbers on the original SDM module had matching numbers with the new module. Few days of driving, Airbag...

Working on my mates VN V6, Where is the Idle screw located at on the Throttle body, I can not see it and I can't find a photo on where it is located. Note that I haven't removed the Throttle body to have a proper look lol. Also what's the best way to check operation of the IAC? (I have cleaned...

I got a mate's VX and with motor running, the radio and wipers don't work. When turning key to ACC and to On (with motor off), radio and wipers work. I jiggled the key when the engine was running and the radio and wipers started to work. I noticed when the key turns to 'Start' it doesn't...

I'm after info on the specs of the Engine Mount Bolts....What type thread etc...

So it was impossible to remove the trans lines from my Autotrans. I just simply cut it off and will fit hoses to the pipe fitting when I refit the transmission. Only problem is, I need to find a replacement end fitting to fit the trans but don't know what size it is or where to even buy them...

I finally got around to removing the Autotrans from my VR Statesman V8. The reason I'm removing the trans, is to replace the drive plate (flex plate) as it was rattling around, which today I confirmed it was the drive plate at one of the Torque Converter bolts part of the plate. I need to know...

Do I really have to lift engine out of the vehicle to reseal the sump? I've read many forum threads but many different views are said on this. Could I lift the motor slightly off the engine mounts and still remove the sump?

VP V6 Auto... My brother's trans is holding gear when trying to reach 60km. It eventually changes gear but takes while to do it. I replaced the trans filter and oil but still continues to do it. It wasn't an actual trans flush, just dropped pan and replaced filter+oil. What is the problem...

So I have a VR V8 Statesman, I bought it with it being lowered (Not sure what type of springs) with 18 inch rims and no Camber Kit was fitted at the time. My tyres needed replacing soon after purchasing the vehicle. Inside wear occurred. So I replaced what was needed. 9-10 months later I...

I have come across a rattle in the last few weeks. I put my statesman on the hoist at work, left motor running and found a rattle between the Autotrans and motor. I didn't have time to remove the bottom housing cover as my HSV fitted exhaust is in the way so wouldn't be a quick and easy job to...

So my mate has VS Caprice with a 304. His problem is that it has a fluctuating Idle (or it's Hunting at Idle) and when accelerating the Revs fluctuates. I seen the needle fluctuate sporadically when accelerating only at certain revs. If that makes sense. Previously he got told to replace the...

I rebuilt my Powersteering Pump 2 months ago, about 3 weeks ago the belt flew off while I were driving. It was an old belt so I assumed it was stretched etc. I fitted new belt on and I have tightened it to the max and it's slipping. I start the car in the morning and every time I take off the...

I have a VR Statesman V8. In South Australia to measure the Suspension Height is from the centre of the Wheel to the bumper and the Legal Height is 'the available suspension travel of a vehicle must not be reduced by more than one third.' What is the standard height for VR V8 (I'm...

I'll tell you the history of my engine's cooling system before I ask my question. Start of the year I replaced my Inlet Manifold Gaskets. I also put sealant around the water ports and at the same time I Replaced the Radiator, Thermostat, Heater Tap and every Hose with new hose clamps. Filled...

Just wondering if anyone has a diagram of the Powersteering Pump on the 304's of the Internal parts, seals and O rings. Mine is leaking at the pump on the shaft. I plan to overhaul it myself and go from there.

My mate has a VY Clubsport Driving above 20km/h there is a vibration in the front end. More so coming from the Left Hand Side. Steering wheel doesn't really feel the vibration. I feel it more in the whole body. I think 19's or 20's are fitted...new tyres and wheels have been balanced and...

Some idiot stole my HSV Badge on my HSV Enhanced Statesman VR.... Where can I get a replacement HSV Badge? I want exact replacement badge with the Red Ring...... It's the bottom left badge. EDIT: for some odd reason the image won't show on this forum but you can right click and copy image...

What is the correct procedure to clear codes for the VT's? Am I able to do it without a scantool? I have heard about removing a fuse and turning ignition on but don't exactly know the correct Fuse and correct way of doing it but by saying that, Does that way actually clear the codes?

2 months ago my brother's VT had starting problem when car would get hot. So I replaced Crank Angle Sensor. It lasted until now so I thought I would replace the entire Ignition System including Leads, Coils, Spark Plugs and Ignition Module. I also replaced the Coolant Temp. Sensor and decided...

I recently bought a new Thermostat after I Replaced my Inlet Manifold Gaskets, All Coolant Hoses and filled it with Coolant for my 304 5L. Now the Motor barely gets to Normal Operating Temperature. It sometimes goes to 1/4 mark on the gauge but most of the time it sits on zero. Is it...

I need confirmation of what type bolts are used to remove the Harmonic Balancer....I have read many threads on this forum and it is a 50/50 answer so far. Some threads were years ago so I want an updated answer. So it's a VT V6 motor. I have heard it's '1/4 UNF' but have been reading it is...

I just finished replacing the Inlet Manifold Gaskets. I went for a test drive, and after it got warm it started misfiring then oil light came on. I turned the engine off and then restarted it. Oil light is off. I got it home checked oil level and it's all good. I left it until the next day and...

I had to remove the bonnet and once I closed it, then it couldn't open. Bonnet latch works, I hear it pop but doesn't lift up. What can I do to release it? The bonnet seems to be aligned properly so I got no idea why it's stuck.

I am in the middle of replacing the Inlet Manifold Gaskets.... I got my mate to do a hot wash and clean the manifold for me. This is the pics of the manifold with corrosion at the Cooling Port ends... 1 Here is a link for a better look View image: 5 L Inlet 1 2 Here is the 2nd pic link -...

Hey I bought a Inlet Manifold Gasket set from Sprints in Adelaide and it has a thin paper/cardboard type gasket and the gaskets I pulled of the engine has a thicker metal/carbon type gasket. Are these available still to buy? I went back to Sprints and that is the only kit they have. Also the...

What would cause the Indicators and CD Player to not work, All at once? I started engine and started to drive and realised the CD player would not turn on and when I went to turn the corner, I realised the Indicators would not work either. I checked the Hazard lights and both indicators were...

Hey I need to know where i can buy a Nutsert Tool My Statesman VR Exhaust hangers have 2 bolts each for holding 2 exhaust mounts. When I removed the bolts the nutsert was removed with 3 out of 4 bolts. So now I have 3 holes but unable to put nuts behind as it's a cross member that is sealed...

My friends car has a leak... found the leak on the side of trans on one of the trans lines that lead to the front of the car. It's the bottom one. It's just needs tightening hopefully... but I can't get it to tighten as the spanner hits the trans sump when trying to turn it. Is there a...

I have a VR V8 HSV Statesman with IRS. My rear tyres keep having tyre wear on the inside. It will take 10 months or so. I replaced these tyres at start of the year because of the same reason. I shouldn't have to fork out money every year on tyres. How do I stop this happening? What can you...

I have the HSV Cold Air Intake setup on my HSV VR Statesman. Mine doesn't have a fan shroud. I bought one for $10 from a mate and was looking at mine and I won't be able to fit it as the Cold Air Intake will not work, it will be blocked. Does Cold Air Intake fitted vehicles have different type...

Statesman VR V8..... So had to drive across Adelaide, today it's a sunny hot day of 31 degrees. On the way back to my house, car stalls and turns off. Temp gauge was 3 qtr. to Hot for a while. Initially tried to start it again, It cranks but doesn't start. I had a paper clip with me, so checked...

I've just relocated my battery to the boot of my Holden Torana LC. Now I have a Battery that is sealed with battery box fitted. I also have the vent tubes. Now the battery has 2 vent ports and both are opposite sides of the battery. My question is... Do I have to place hoses in both vent ports...

My Statesman V8 has the problem of RH stalling and I have read on JC forum about the return hose not being connected. So I removed the fuel pump and found that the Return Line is connected but by only a cable tie holding the fuel pump end. (The swirl pot end had a hose clamp fitted to it and is...

I have a VR HSV Statesman.... just wondering what is the difference between the HSV VR Statesman to a Regular VR Statesman? I'm not fussed about interior differences... but would like to know differences on the engine and components with it Is the ECU different? I have heard that some...

Recently I have been hearing a humming sound from rear of car, I checked the boot and underneath the car and found it's the fuel pump. I have also found it changes its pitch noise when I press power windows switches. I did a forum search and members have just simply just replaced theres even...

My mate has a VR V6 commie and suddenly he is unable to turn the key in the Ignition. Would this need a new Ignition Barrel?

So months back car was jacked up in wrong jacking point and bent the lower radiator support panel (Is that the correct term for this panel?) and Radiator was lifted to the point whereas I couldn't close the bonnet. So I removed radiator and found lower panel was bent. I tried straightening it by...

I've been looking at Suspension for my Statesman and I have been seeing Stage 1, Stage 2 and Stage 3... What does these stages mean?

My mate wants to do a auto to manual conversion on his VS.... This is what he has said to me: "Bolt pattern, 6 bolt is for a series 1 VN and you don't need the loom for a conversion, you just bridge the neutral safety and yeah comes with everything you need mate, ecu, pedal box, clutch...