crank angle sensor

Hi All, My Ecotec V6 is showing the signs of needing to replace the crank angle sensor. Engine light flashes within a few minutes of driving and then if engine is turned off after a few minutes of driving it won't start back up again after at least 20 minutes. Can anyone one recommend a crank...

VYII Wagon 2004 Ecotec V6. Removed crank pulley and fitted new cam and crank sensors this morning. Problem I am having is lining up keyway when putting pulley/balancer back on. She is a tight fit and when I attempt to rotate balancer by hand to find where keyway fits, the crank just turns...

So ive just had my crank angle sensor replaced and the car has chucked a dummy spit!! No central locking. Lights coming up on dash. Cant start. Security codes coming up etc. The mechanics are thinking semding away bcm and ecu ?? They've checked fuses etcc. Has anyone got any idea. Or if its...

Hey all I can not work out what is going on with my car and need as much advice and suggestions as I can get! My 5.7 Crewman Auto has all of a sudden desided it wants to have a drop in rpm below idle every time i get off the gas and can stall because of this. When it does the "decel rpm drop" it...

Hi all new to forum. Need some help my vy calais stop starting out of nowhere so i replaced the key and iv'e had two mobile mechanics look at it and got nowhere. It finally got it to run out of nowhere drove it very slowly to a mechanics who ran a snap-on scan tool it threw out cam/crank sensor...

hi all looking for some advice on the problem my vt has been giving me before i throw more $$$ at it! Drove it this morning to take the Mrs to work without any issues about a 30min drive, then 4 hours later going to pick her up about 2 minutes after leaving home it starts misfiring still...

Hi everyone, I have a VS Equipe V6 Ecotec which for the past few months has had difficulty in starting when cold. Sometimes the car will crank 10 times before it will fire but this morning it failed to start despite numerous attempts to crank it over. A very good friend of mine checked the...

hi everyone. my mrs has a 97 vt which cranks but wont start. at first she would either swap a couple of the relay fuses around or lock the car with the remote on the key then un lock multiple times and most of the time eventually it would start . sometimes after doin this a couple of times but...

Hi all... been having a bit of drama with my car lately, (auto trans) it stalls while I'm driving & although I have an idea what it may be, I thought I'd reach out for other opinions... Symptoms - I'll be driving & all of a sudden she will decide to stall from time to time (I've noticed this...

Hi people, I noticed there is not a how-to thread for replacing crank angle sensors on the ecotec, yet how popular CAS issues are, I thought I would write one up after recently replacing the CAS in my ute. What you will need: Socket set (make sure you have a 24mm for the harmonic balancer...

Hi, i am new to this site. I am wanting to know if anyone can help me. I am having Problems with my VS Commodore. A few weeks ago my Fan Belt snapped and wrapped around the bottom Pulley, which snapped the crank angle sensor and destroyed the bottom pulley. I replaced the Fan Belt...

Hey Guys I have a 2000 VX Commodore Berlina = Automatic. I have had a few problems in the last couple of months. Firstly I had trouble starting it, so the NRMA recommended I get a new battery. After about a week, occasionally it would still be hard to start and the car lost all power while...

Hey Guys. I Own A VP 92 Commodore N it Drives Beautiful wen i start it from cold then wen it warms up a lil it trys to stall itself but only just stays alive. the other day around the corner from my house i gave it a little bit to see wat it would do so i put my foot down then it kinda felt like...

My Guide For those who dont know how to replace the Crank Angle Sensor(CAS)for an RB30 Tools: Phillips Head Screwdriver Spanner to fit Rotor Arm Bolt Hands X 2 Note: Disconnect Negative Battery Terminal Before your Start <--------->Thanks jatsvl 1. First Leave the Dizzy in the...