Dmcsniz
New Member
- Joined
- Apr 22, 2024
- Messages
- 3
- Reaction score
- 0
- Points
- 1
- Age
- 31
- Location
- New Zealand
- Members Ride
- Holden BERLINA WAGON V6 A 2007
Hello so my holden berlina (commodore) had a check engine light come on i plugged in my obd2 and it said misfire on cylinder 4 as well as the poo16 code (Crankshaft Position-Camshaft position correlation Bank 1 Sensor A)
So i replaced all the spark plugs because im not sure which is cylinder 4 and cleared both codes.
after about 100km the poo16 code came back and not the misfire code.
Engine still runs very rough especially at low RPMS
I have cleaned the Mass Airflow sensor and put a new air filter into it.
I pulled out both camshaft position sensors and they were very dirty so i gave them as good clean as i could with mass airflow sensor cleaner and a clean rag.
Still running very rough and it is going to cost me $450 to replace 1 sensor so I thought id come to these forums to see if anyone has any ideas for me to do before having to pay that much and it might not fix the problem.
Any help is much appreciated thank you.
2007 Holden Berlina V6 A (commodore) 3.5L
So i replaced all the spark plugs because im not sure which is cylinder 4 and cleared both codes.
after about 100km the poo16 code came back and not the misfire code.
Engine still runs very rough especially at low RPMS
I have cleaned the Mass Airflow sensor and put a new air filter into it.
I pulled out both camshaft position sensors and they were very dirty so i gave them as good clean as i could with mass airflow sensor cleaner and a clean rag.
Still running very rough and it is going to cost me $450 to replace 1 sensor so I thought id come to these forums to see if anyone has any ideas for me to do before having to pay that much and it might not fix the problem.
Any help is much appreciated thank you.
2007 Holden Berlina V6 A (commodore) 3.5L