Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.

New Posts Contact us

Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

Recent content by jigz

  1. J

    Harsh start and high idle at startup

    The codes I pulled by bridging pins 5 and 6 were: 0506 - Idle Control System RPM lower than expected 1361 - Top Dead Center sensor The crank angle sensor has only been recently replaced
  2. J

    Harsh start and high idle at startup

    2000 Holden VX. By harsh start I mean, it seems aggressive. Rarely, a check engine light will come on, and it won't start, but 99% of the time it starts fine, just a bit harsh, like almost a clunk at times. Brand new Bosch starter motor. Then, it revs up to about 2000, stays there for what...
  3. J

    Too much fuel

    Strange thought: While working on car, I had plenum chamber and fuel rail sitting upside down in garage (injectors sitting up in the air). Not too sure on internal mechanisms of injectors, but could having them sit upside down for too long cause some kind of valve in there to stay open? Like I...
  4. J

    Too much fuel

    Will sort injectors. Re: MAF. Just unplugged MAF and started car, idled a little lower and check engine light came on. Looked like more fuel coming out of tail pipe? Plugged MAF back in and started car, idled a little higher, no check engine light. Looked like less fuel out of tail pipe...
  5. J

    Too much fuel

    Checked the wires, they all look okay. Great info, thanks.
  6. J

    Too much fuel

    The cheap ebay ones were in and functioning fine before disassembly. But I get what you're saying.
  7. J

    Too much fuel

    Rough idle, guessing because there's too much fuel in cylinders. Various places. I changed the LIM gaskets. I don't understand how the LIM gaskets relate to fuel in oil. You have the intake ports and the coolant ports. Either way, there is too much fuel going into the cylinders. More likely that...
  8. J

    Too much fuel

    They're cheap ebay ones. Recently dismantled and reassembled top end, but were working fine before disassembly. Couldn't possibly be MAF? Telling injectors to let through too much fuel?
  9. J

    Too much fuel

    No fuel in vacuum hose from fuel pressure regulator. It's also a new regulator.
  10. J

    Too much fuel

    Dip stick smells like fuel
  11. J

    Too much fuel

    Okay, hadn't thought of that. Injectors are all new.
  12. J

    Too much fuel

    All new
  13. J

    Too much fuel

    Just replaced the LIM gaskets, it's not water.
  14. J

    Too much fuel

    Pretty sure its fuel. Exhaust reeks of it, and I've put my hand over the exhaust and smelt the drops and its fuel. There's fuel on the driveway under the exhaust pipe. Car also stalls after revving for a while - I suspect its flooded.
  15. J

    Too much fuel

    Hi folks, My VX has way too much fuel being injected, as in, there is a spray of unburnt fuel flying out of the exhaust. I have looked on here and am aware of the usual culprits (MAF, IAC, IAT, PCV, o2 sensors, DFI, coils). I have so far replaced the IAC valve (looked gummed up and old and it...
Top