Welcome to Just Commodores, a site specifically designed for all people who share the same passion as yourself.

New Posts Contact us

Just Commodores Forum Community

It takes just a moment to join our fantastic community

Register

wiring

  1. J

    Instrument Cluster haywire

    Hi there, I have just installed a sub and amp into my ute, which all works fine! However, since doing this, my instrument cluster now doesn't work, the speed, revs, temp and fuel all don't work and the indicators on the cluster flash rapidly and the computer just displays my service...
  2. I

    Help Holden VT Engine to dash Loom (I think)

    When i installed my headunit or my sub, when i was running the power cable i ran it through the i think its the main firewall underneath the driver side and to get it through i had to drill, and i think i remember hitting the look because i took the drill off and it looked like there was plastic...
  3. F

    vy wiring

    Hi I was just wondering where I could splice into to get 12v. Please if you could show a picture thanks
  4. VP-EXCHASER

    vp v8 body loom pinout

    Chasing a decent wiring diagram or pinout of the 2 plugs 1 grey 8? Pin and 1 black 6 pin plug near the fuse box in the engine bay. And the plug near the ecm that connects the engine loom to the body loom.
  5. V

    Need help with wiring factory VH Tacho?!

    Hi All, Recently, i've been restoring an old vh project and have come across the instrument cluster, which is an sle equivalent with the tacho, but upon changing the dash lights to the led globes, ive noticed that the tacho isn't even connected? I have no knowledge with tachs and how they are...
  6. S

    Vs commodore fuel pump head scratcher

    Hi guys, I have recently done an engine swap in my 95 vs executive. I wired everything up went to start it and all it did was crank. First thing I checked was spark. Second thing I checked was fuel. I noticed my fuel pump was not priming after letting it sit for about an hour before trying to...
  7. G

    VY Dash and LS1 custom install, wiring advice needed

    hi all, I hope i have posted this in the right section. I have fitted a VY firewall along with the complete dash including the heater box and LS1 engine to 1985 trans am. I am using the VY chassis wiring loom along with the fuse box, relay box, PIM, BCM and ECU. not using traction...
  8. W

    VT/VX Cluster Pins

    G'day, Anyone know which pins on the back of a vt/vx cluster need wiring up to power it up while out of the car? As well as get the back lights to come on. Cheers!
  9. M

    Strange Vn ignition wiring short, thoughts and suggestions much appreciated.

    Hey everyone :) I have a 91 VN Vacationer auto, motor wise it runs great never missed a beat the auto trans isn't the best and will occasionally stall when you put it in drive but only rarely other than that its a pretty clean reliable car had her for about 3 months and i don't exactly nanna...
  10. C

    Vs engine and gearbox swap

    Hey guys, first post and here's the deal... I've gone out and bought a running and driving 98 VS parts car with a manual gearbox and Ecotec in it. I'm wanting to swap these into my current ute 97 VS with an auto and Ecotec. The questions I keep coming back to are these: Will it be easier...
  11. M

    ex cop ve ute problems with internal lighting

    i recently run my battery flat i discounted it recharged it and once reconnect my dash and stereo were stuck in night mode , it is a ex cop ute so it has the switch near the sun cases which never actually worked the whole time ive had the car mind you but ive reset every setting push both...
  12. R

    Vp V6 immobiliser problems

    Hey, I have a vp v6 which the immobiliser has been over ridden to an extent where you can start the car and while the car is running it will beep and flash "press remote" for about 2 minutes. I decided too look into hard wiring it as it did not come with a key and it seems as though some one has...
  13. E

    [VT-VX] How to install an aftermarket tacho in VT/VX (I've been told it is the same in VY/VZ)

    So, there is a fair bit of debate as to how this is done but I'm going to tell you the relatively simple way. Step 1. Remove the fuse cover panel under the steering column. Step 2. Remove the dash facia. The first step is to remove the to screws at the back of the piece around the gear...
  14. J

    colour code for all wires from ecu. Desperate!

    i have a vx commodore on gas. anyway something to do with the module is cutting my car out while i am driving on gas. my gas light switches off power goes battery light comes on and the car comes to a slow stop. it runs fine on petrol though as long as the gas is disconnected. but it would be a...
  15. D

    Power Window Conversion in a 98 Executive

    Hey Guys (and possibly girls) I've decided that i'll keep my VT for another two years before i upgrade and one thing that has always bugged the living **** out of me was the manual windows. I have been sifting through the various posts on here about conversion, problems, fixes, and the...
  16. Holden vz

    Wiring Problem Headlight Switch

    Hey Guys Ive recently put in fog light on my vz but it didn't have wiring so i got a wiring set of eBay everything is working but i wont to control the fog light of the ss headlight switch instead of the one provided with the wiring set i just want to know where to tap the switch wires into...
  17. A

    Radiator thermo cooling fan not working

    After doing a great deal of research i have managed to get most of the information i need to troubleshoot my radiator thermo fans not working. I can't find the last bit of info i need to finish off the job. Background info: Radiator thermo fans not coming on at all when car is running...
  18. S

    help with project

    Hi all. I'm new to this so bear with me. i Have a 1994 VR wagon, now dont kill me but im thinking of installing neons in the footwells. i want to tap into the cigarette lighter for power. my question is does any one know what wire the cigarette lighter is, what colour etc and any tips for the...
  19. Mzil

    Headunit Short out/Fuse problem

    Today i was trying to switch over a head unit in my VS. I had all the power wiring cut off from the old harness onto the new one just to test the new one. Anyway it all worked fine up until one of the wires touched the metal on the inside of where the head unit sits. This caused a spark then...
  20. Mzil

    Wiring/Fuse Problem with Head unit

    Today i was trying to switch over a head unit in my VS. I had all the power wiring cut off from the old harness onto the new one just to test the new one. Anyway it all worked fine up until one of the wires touched the metal on the inside of where the head unit sits. This caused a spark then...
  21. jayden.2.2

    Running cables to boot in ve.

    Hey guys, What's the easiest way to get cables from the cabin to the boot? I read that you have to take out the back seats? Is there an easier way? Is there a special opening for all the cables, considering the battery is in the boot also. Thanks.
  22. M

    VX II Power Windows

    Im trying to put power windows into the VX Series 2 i have, at the moment i know i need to up grade my current Low-015 bcm to a Mid-212 or Mid-013 (found out that from Holden) I also know my car main body loom can support them because i have located the big plug for the power window controls...
  23. M

    Rear Pass window stopped working after wiring

    Gday All, Today I was installing some 6x9inch in the rear parcel shelf, and after removing door trim and running the wires underneath the carpet, and screwing door trim back down, my rear passenger power window has ceased to work, both from the main switch in the front seat, and the...
  24. Wherry951

    .

    .
  25. Wherry951

    RB25DET Wiring Into VS Calais

    Hey guys i'm putting a RB25DET in my VS Calais. Supposedly they bolt onto a VL Crossmember which slots into the VS Engine bay. I dont care if its not the fastest car i just want it uniquevas i have access to a M3 CSI when i want a thrill Im just wondering if any of you could give me any help...
  26. SV6 Matt

    09 SV6 ute flute blinlers.

    How.do.I access the.wires.to my.fender flute blinkers, I've just purchased some new side mirrors with LED blinkers in them, and I've organised an auto electrician to help me install them, but in.order to.do so I need to remove my door trim, feed the wires through there and through the.grommet at...
  27. Abdul

    Ve rear aux wiring harnesses

    Hi guys, I tried looking for wiring harnesses for audio and video for the rear AUX (VE) at many stores but had no luck. I found a website that sells them for $80 which is too much for what it is. My question is if I was to get these wiring harnesses in, and started selling them, would there be...
  28. R

    VT power issues?

    Hey all, Just wondering if anyone could give me some insight on some strange going on's in my 98 VT acclaim. It seems to be the power it cutting out, i have 2 amps one running the front speakers one running the sub the one that runs the front speakers cuts out and the speakers sound like...
  29. B

    1989 vn wiring problem

    HELP I changed over my interior from the stock to a custom ss interior , as I removed the dash I thought I labelled mist of the wiring groups , so I put i t back together and now when I connect my battery my headlights go on and wont turn.off at all, also in addition my temp gauge instantly goes...
  30. M

    Ve fog light switch modification

    Hi guys, As there is no existng plug on my VE 60th Anniversary to attach a foglight loom to, i have purchased an aftermarket wiring kit. I have attached a circut daigram of the aftermarket loom i currently have. On the print, below the aftermarket switch i have a plug. I was wondering if...
  31. T

    fuse rail help (vk)

    hay guys i no the relocation questions have been asked time an time again... but can some help me or link me to a thread were its start to finish... iv worked out a way to do it but its not very neat or tidy, so before i do it that way just thought i would ask if some one could help me.... i...
  32. jamiasvu

    LX8 Adventra factory AMP wireing for AMP/SUB upgrade

    Hey guys, I've got a Pioneer 12" and a JL Audio 400W amp (which is perfect fit for putting in the same spot as the factory amp) and I have cut the loom plug that connects to the factory amp. Now I am unsure of the wireing and can not find it anywhere on the net! So I have 2 yellow and 2...
  33. V

    crewman Bluetooth

    hey guys I've got a parrot ck3000 Bluetooth device and need to wire it up to my vz crewman. can anyone give me a wiring diagram or how to do this. thanks.
  34. N

    93 VR V6 Berlina wont start? Makes one click when i turn ignition and thats it..

    I removed the injectors fuel rail and a few necessary wires and hoses to get the upper manifold off..I cleaned the lot ( was having serious issues with starting and it ran like a bucket of S#$T..) Changed spark plugs leads , did an oil change..When i replaced everything, i went to start the car...
  35. V

    My vs is having some electrical problems

    Hi guys.. My vs equip is having some electrical problems. Such as when the car is turned on the hazard lights flicker on and off, the head unit doesn't work when I have the sub and amp connected but if the sub and amp is disconnected the head unit turns on but when power windows are used the...
  36. J

    Help with VS UNinstallation of Viper alarm

    Hi Guys, just got a concern with the local auto elec trying to take me for a ride. I have had issues with a Viper Alarm in my VS S and no it was already in there when I bought the car! The Viper model on the back of the remote is dei471. So I have had it uninstalled on thurs its now mon. When i...
  37. J

    Hazards, Back Demister and Aircon Buttons all not working...

    Non of the buttons on the middle panel seem to turn on Aircon, Hazards and Back demister on my VS wagon. Ive checked the fuses and they are fine. didnt think it would be them anyway. where is the next place i should look if they all arent working....?
  38. M

    A-Pillar mount wiring, how to on the SV6 Series 2

    I found online a mounting kit for the tomtom (anything for that matter) which can go on the A-pillar. I dont want to have a power cable draped anywhere, and was wondering what wiring I would find under the drivers side A-pillar? I don't have the smokers pack, but is there a plug for a...
  39. B

    VY Headlights

    I recently brought some VY Headlights off ebay and am in the middle of installing them. The problem is the new ones i am trying to install wont fit the one small particular wiring connection. Do i just mod it or can i buy a new one to fit? Thanks
  40. P

    Wiring Sat Nav cable through dash on VX Berlina 2003

    Hi, This is my first post here so hopefully it is in the right place and sorry it if is not. I have just purchased a GPS system for my VX Berlina Series II and want to mount it without having the cable just hanging across the dash as it just looks plain ugly. Does anyone know how to wire...
Top