20 x 10.5" wheels

[Joshyy89]

Thanks mate I'm quiet happy with them. I felt really bad taking off the stockies and had some buyers remorse but I'm all good now lol.

Have to say the Potenzas are very very good as far as noise goes.

I had the same feeling without seeing them on a car yet but seeing yours makes me feel better. Just regretting going 10.5

Hmm i dunno what tyres im going yet. My potenzas were ok untill they started to wear abit

 

[VESSVBLACK]

The 10.5 will look tough as with deep concave only .5 inch wider so
I wouldnt regret it with right offset it will sit fine , if worse comes out , koya will sell you 2 rears , individually.

 

[RED LION]

Exactly. Will look very nice.

 

[Joshyy89]

The 10.5 will look tough as with deep concave only .5 inch wider so
I wouldnt regret it with right offset it will sit fine , if worse comes out , koya will sell you 2 rears , individually.

yeah true shoud look good, should get them this week sometime....

Exactly. Will look very nice.

what tyres did you go?

 

[RED LION]

yeah true shoud look good, should get them this week sometime....



what tyres did you go?

Potenza S001. Really happy with the lack of road noise. Can't wait to get the guards rolled so I can actually put it through some corners.

 

[Joshyy89]

Yeah it was borderline. But again depends on the tyre, my rears sat like that and a different tyre up front had less rim protection with a wider tyre compared to the rim width.



Spot on. Hsv rears are in the vicinity of 20x9.5 +57.

I've seen 305/30R19's on a 19x11 +54.

Somewhere around the +50 mark is ideal for maximum tyre width/least rubbing, but I know +43 is common to get the concave Koya's over big brakes.

The Koya SF11 will easily fit over big brakes without problem but don’t confuse offset as being the reason a rim suits or doesn’t suit big callipers as it’s the centre design that will have the most influence and cause headaches.

Anyone who would like deep dish rims on many modern vehicles will have faced this dilemma.

Also if the HSV boys are talking about fitting 295's to their OEM rims then be aware HSV has very conservative offsets for their rim widths.


Koya SF11

.

Thanks mate I'm quiet happy with them. I felt really bad taking off the stockies and had some buyers remorse but I'm all good now lol.

Have to say the Potenzas are very very good as far as noise goes.

Ran 255/35 an 285/30 no issues a part from nsf srubbing every now an then maybe due to having it too low but happy with them, thanks all for the

 

[RED LION]

Looks perfect mate. Well done!

I wish I went the 275/30 instead of the 275/35

 

[Joshyy89]

Looks perfect mate. Well done!

I wish I went the 275/30 instead of the 275/35

Always can do that next time. I just went shitty rears just incase there was issues but there pretty grippy haha

 

[panhead]

View attachment 192922

Ran 255/35 an 285/30 no issues a part from nsf srubbing every now an then maybe due to having it too low but happy with them, thanks all for the

Looks good.

Now that you can see what 285/30 fits like, do you think 295/30 would also work?

And doesn't the Commodore look much better with a 255/35 on the front and that little bit of extra grip will give you a better turn in.

Now for a few more photos showing off the different angles.


.

 

[Joshyy89]

Looks good.

Now that you can see what 285/30 fits like, do you think 295/30 would also work?

And doesn't the Commodore look much better with a 255/35 on the front and that little bit of extra grip will give you a better turn in.

Now for a few more photos showing off the different angles.


.

Hmmm think its safer with 285s. 295s prob wouod need to leave at this height. Ganna try drop abit more in the rear tomorrow

Yeah soo much better. Scrubs on the nsf alil but like the height

Ill add some when i get on my laptop