paulthehutt
New Member
- Joined
- Feb 20, 2015
- Messages
- 2
- Reaction score
- 0
- Points
- 0
- Location
- woodville
- Members Ride
- 2006 holden barina
hi just after some advice regarding my partners 2006 barina.
I have just replaced the thrust bearing as the old one was shot.
On reassembling and testing the only gear i can get the car to move in is reverse.
I can select a few other positions but they all lock up the gearbox when i release the clutch.
I did not pull the gearbox apart at all except from removing the drive shafts and pulling it off the engine to replace the bearing.
Its got me really confused, and input would be greatly appreciated.
I have just replaced the thrust bearing as the old one was shot.
On reassembling and testing the only gear i can get the car to move in is reverse.
I can select a few other positions but they all lock up the gearbox when i release the clutch.
I did not pull the gearbox apart at all except from removing the drive shafts and pulling it off the engine to replace the bearing.
Its got me really confused, and input would be greatly appreciated.