MACE

how do the mail order tunes work i am doing an L67 top swap and want to use stock computer it is manual so using original loom also not sure how it works

Hey man are you able to message me thinking of getting a det of rockers for my vt v6 of you

Hi there I have a vx holden berlina v6 and I want a cam put in it and I know I need to tune first but just wondering what cam you would suggest for someone that just wants a but more power and a very nice growly deep cam when in idle and when taking of and just driving in general I just want a little bit of more power and speed but mainly just want that nice lumpy sound.

Hi there, Steve is it?
I've been looking g at your rockers for my l67, and the other mechs in my workshop recon that the valves will hit? This doesn't make sense to me as why would u design something tht cahse a valve hit, so the stupid question is.. Will they hit? And do I need special push rods and or rocker covers to suit?

HI I have a 99 VT II with the L67 motor in it, i have to rebuild the supercharger because the bearings in the snout have gone so while it is apart I thought I might pull the intake manifold as well and get both the intake and Supercharger ported out by you guys, what is the best way of sending it down to you and how much is it likely to cost, I am in Townsville.

Cheers Chris

Hi. Just wondering what you think of my LS2 cold start up https://youtu.be/TPZKf8sp9Kc

Hey
im in the process of putting a vp i picked up for cheap back on the road and am about to order a few part from you guys .
Im picking up
#70mm throttle body
# mitsubishi injectors (not from you guys )
#cold air intake
#coil pack
#82 degree thermostat
#extractors 2 1/2 inch exhaust (not from you guys )
the question is im lookong at finishing the order off with a set off cams and rockers to suit. And was wondering what the cost of a set of both to suit would roughly set me back sent to south nsw. ....... and also what memcal would you guys sell to do these mods so i can get it tune correct as possible when tuned
thanks for any info .

Hi mate. Purchased a few of your products and just wondering how id go getting some stickers.
Cheers

Hey there.

Is it possible to re use the plenum and manifold spacers again ?

And if I was to provide both spacers what would your rough price be on installing them ?

Thank you

Hi i have a 69mm throttle body but on installation on my vx v6 na auto i noticed a delay in shifting to second and flat spots in acceleration. is there any way to fix this problem or will i need a tune? i alsi have a 12mm plenum spacer and 25mm manifold insulator which i want to install but will this cause issues like thee throttle body?

Thanks in advance for any help