Are you sure you reinstalled it correctly?
No i havent yet but i will check tomorrow. Have any idea on what it should be?
Using a volt metre, check the reference voltage from the PCM. Connect the positive probe (+)
onto the reference wire (Grey) and the negative probe (-) onto the earth wire (Black/Yellow).
The voltage should read approximately 5.0 Volts.
Next, check the TPS signal voltage.
With the throttle fully closed, connect the positive probe (+) of the volt meter onto the
signal wire (C Terminal on the TPS) and the negative probe (-) onto the earth wire (B Terminal on the TPS)
Gradually open the throttle and observe the TPS sensor voltage.
There should be a smooth change in the voltage values as the sensor travels from idle to full throttle.
The voltage should increase to approximately 4.5 to 5.0 volts.